Therma-Steem® Model 400
February 15, 2019
22
NYLON DETAIL BRUSH
1” Dia. 2
-
1/2” Dia
.
Use - to be used where there is a possibility of scratching
the surface, such as Bath Tubs, Door Jambs, Grout, Glass
Shower Doors (Pre-steam) Etc. When in doubt about
which brush to use, the Nylon brush first. This brush can
generally be used on almost any surface except on flat
latex wall paint and non-water proof ceiling tiles.
STAINLESS STEEL DETAIL BRUSH:
1” Dia.
2-
1/2” Dia.
Use - Stainless Steel is hard and should only be used on
surfaces that are scratch resistant. Always test in a small
area before proceeding. This brush can be used on
surfaces such as masonry, certain tiles such as Quarry tile
and high quality stainless steel. This brush can be used
to remove some painted areas if the surface will undergo a sanding process prior to
repainting. If in doubt test an out of the way area first. The stainless-steel brush will also
leave a black mark, which is difficult to remove on certain types of tile.
BRASS DETAIL BRUSH:
1”
Dia. 2-
1/2” Dia
.
Use - This brush can be used on many metal surfaces as
well as on some Tile, Ovens, Etc. Always test on an out of
the way area before to Use. Brass is softer than stainless
steel and will consequently wear faster. This brush works
well on oxidized aluminum surfaces, it will however, have
a polishing effect and make the surface look brighter than arras which have not been
cleaned with this tool.
