Therma-Steem® Model 400
February 15, 2019
16
v.
Turn off the unit and let it rest for 30 minutes
vi.
Repeat this process until the steam flow returns to normal (could be 2
to 3 times). NOTE there is an odor associated with this process
After each use the water tank should be emptied.
We realize that it’s tempting to just
leave the water in the tank for the next cleaning go-around but taking the time to empty
the tank before storing will lessen scale build up from mineral deposits. Not to mention
avoiding the musty odor that can be produced from steaming with stagnant water.
STAINLESS STEEL BODY:
The housing and handle of your THERMA-STEEM® Industrial 400 are made of stainless
steel. We recommend that you preserve the finish by keeping the machine dry and
polished. Use a good stainless-steel cleaner, being careful not to rub off any instructions.
FILTER CONNECTED TO THE PUMP:
The filter connected to the pump (see below) needs to be checked on a regular basis.
Even if distilled water is being used in the machine, the filter may still become clogged.
To check the filter, look for discoloration and/or detach it from the pump and see if you
can blow air through it. If it is discolored or Resistance to the passage of air through the
filer, the filter should be replaced.
ELECTRICAL REQUIREMENTS
:
Check your serial plate on the back of your machine to determine the voltage. This
machine is available in 120 volts or 240-volt, single phase.
Filter
