Themis RES-XR4-1U, Руководство по установке

Страница: 78 / 198

RES-XR4-1U Installation Manual Version 1.5
2-10
Themis Computer
2. After the air-flow deflector is removed the memory modules will be exposed
(see
Figure 2-2 on page 2-6 and Figure 2-3 on page 2-7).
The following procedure explains how to install the Memory Modules...
3. If a module is already seated in the slot you have selected for installation,
remove it by gently pressing down and outward on the latches at both ends of
the slot (see
Figure 2-6 ), then pulling the old module directly up from the slot
until it is free of the connector (see Figure 2-6 ).
4. Before inserting a new memory module into the vacant slot, make sure that
the two latches are pulled outward away from the center of the slot.
With the latches in the outward position, gently insert the new module verti-
cally into its slot and press firmly downward until it snaps into place.
5. When module replacements are finished, replace the air flow diverter and
secure it with the eight screws previously removed.
6. Replace the PCI card retainer bracket and secure it with the single screw
removed in Step 1 on page 2-12.
Figure 2-6.
Memory Module Removal
downward &
outward at
each end
Press latch
Note: Make sure the memory module has the proper orientation by align-
ing the alignment notch at the bottom edge with its counterpart ridge at
the bottom of the slot.