Themis RES-22XR3, Руководство по установке

Страница: 64 / 162

2-14
Themis Computer
RES-22XR3 Installation Manual - Configuration 1 Version 1.3
Figure 2-12 on page 2-13) to engage the Locking contact area (see Figure
2-13 below) onto the locking stud.
2.1.7 Power Supply
Each load-sharing (N+1 redundant) power supply can be hot-swapped while the sys-
tem is still on and operational.
2.1.7.1 Removing a Power Supply
Perform the following steps to remove a power supply:
1. Unplug the power cord(s) from the socket(s) in the power supply module(s).
2. Remove the two screws holding the power supply locking bracket to the chas-
sis (see
A , Figure 2-14 ). Put the locking bracket in a safe place for further use.
Figure 2-13. Locking Contact area
Locking Contact
Font of System
Rear of System
Area
Note: At least one functional power supply must remain in the chassis at any giv-
en time for the system to remain operational.