RES-22DCX Installation Manual
2-14
Themis Computer
2.1.5.2 Installing a 60-mm Fan Housing
Perform the following steps to install a 60-mm Fan Housing:
1.
Insert the replacement 60-mm fan housing into the slot formerly occupied by
the removed housing, aligning the key at each end of the new housing with the
alignment slot (see
Figure 2-11
) in the fan-mounting bracket.
2.
Connect the 4-wire cable from the new 60-mm fan housing to the mother-
board connectors from which the replaced housing cables were removed.
Each cable connector is keyed to prevent incorrect cable insertion.
3.
Tighten the two captive screws at each side with a Phillips screwdriver until
the 60-mm fan housing is firmly secured to the fan-mounting bracket.
Figure 2-11.
Rear 60-mm Fan Housing Partially Removed
Knurled Phillips Screw
Front 60-mm-Fan Housing
Rear 60-mm-Fan Housing
Alignment Slot
Alignment Key
Fan-Mounting Bracket
Содержание RES-22DCX
