8
• To switch the PIR from presence to absence mode, press the
lock/unlock
button and you will see 2 flashes from the LED
receiver of the PIR, this indicates that the PIR is unlocked and
ready to receive further instructions from the remote control.
Next press the
Semi Auto
button on the
IR10AB
remote
control. The LED receiver light will flash once for up to 2
seconds and dissapear, this indicates that the PIR is now in
Semi Auto
(absence mode).
• When the PIR set to absence mode, the unit will not switch
on automatically when someone walks in the detection area.
• The person in the room must press the retractable push
button for the light to switch on. From this point onwards as
long as detection in the area has constant movement, the
PIR will continue to keep the luminaire or attached load
swtiched on, until the subject has moved out of the detection
area and the time delay function takes over.
• For example if set to 10 minutes the PIR will begin to
countdown from this value once nothing is in the detection
area. If a subject is detected the time delay will reset.
Switching From Presence To Absence Mode:
Switching From Absence To Presence Mode:
• To switch the PIR from absence to presence mode, press the
lock/unlock
button and you will see 2 flashes from the LED
receiver of the PIR. Next press the
Auto
button on the
IR10AB
remote control. The LED receiver light will flash
twice and dissapear, this indicates that the PIR is now in
Auto
(presence mode). There will be up to a 1 minute delay
in changing modes where the PIR will not switch.
