The Handy THHPWVAC, Руководство оператора и список запчастей

Страница: 18 / 36

TROUBLESHOOTING – PRESSURE WASHER
PROBLEM POSSIBLE CAUSE SOLUTION
Pressure washer does not
start when trigger is
depressed 1. Power cord not connected to
power source
2. Switch is off
3. RCD has tripped
4. Property trip switch has
triggered
1. Connect the power cord to a
suitable electrical supply
2 . Turn switch on.
3 . Press reset button on the RCD
plug.
4 . Reset trip switch within
property fuse box. Make sure
pressure washer is connected
to an individual branch circuit
only. If using an extension cord,
make sure it is sufficient
enough to carry the current of
the pressure washer.
Pump doesn’t produce
pressure 1 . Inadequate water supply
2 . Multi-Lance leaks
3 . Nozzle is clogged
4 . Pump is faulty
5 . Air in line
6 . Water inlet filter is clogged
or dirty
1 . Provide adequate water flow.
2 . Check connections and / or
replace trigger gun or lance.
3 . Clean nozzle.
4 . Contact authorised service
dealer.
5 . Squeeze trigger to remove air
from line.
6 . Remove the water inlet
screen, rinse with warm water,
then replace in unit.
Machine doesn’t reach
high pressure 1 . Diameter of garden hose is
too small
2 . Water supply is restricted
3 . Not enough inlet water
1 . Replace with 3/4 in. garden
hose.
2 . Check garden hose for kinks,
leaks, and blockages.
3 . Open water source to full
force.
No detergent 1 . Water supply is
inadequate or clogged
2 . Wrong nozzle is attached
1 . Check garden hose for kinks,
leaks and blockages.
2 . Attach Multi-Lance and set to
low pressure.