Textron 62706, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 87 / 108

en-87
9 ADJUSTMENTS
9.15 HEIGHT OF CUT CLASSIC XP™ REELS ___________________________________
Work Bench Setting
NOTE: All three cutting heads MUST be accurately set
at the same height of cut to insure an even cut.
Bedknife adjustment must be made before setting the
height of cut.
1. Set the height of cut on the gauge block (Part No.
892010) by turning the wingnut until the distance
between the bottom of the screw head and the top
of the gauge block equals the desired height of
cut.
2. Loosen the locking nut on one of the front roller
adjusting brackets just enough to allow
adjustment.
3. Hold the gauge block (Part No. 892010) across
the bottom of both the front and rear rollers near
the roller adjustment bracket and adjust the front
roller until the cutting edge of the bedknife comes
up to touch the bottom of the gauge screw head.
4. Tighten the locking nut and repeat the procedure
at the other end. After adjustment has been made
at both ends, go back and recheck both ends.
5. Make sure all three cutting heads are set without
changing the height of the gauge screw.
1. Loosen Locking Nut
Height of Cut Adjustment
A = Rear Roll
B = Front Roll
C = Gauge Screw Head
D = Bedknife
E = Height of Cut