Textron 070544, Инструкция по безопасности, эксплуатации и техническому обслуживанию/Список запасных частей

Страница: 53 / 134

en-53
OPERATION 6
6.4 TO FIT THE CUTTER DECKS TO THE MACHINE ____________________________
Front Deck Mounting
1. Make sure the hydraulic hoses are plugged. Start the
engine and lower the lift arms (A), stop the engine and
remove the ignition key.
2. Position cutter deck and align the lift arms (A) with
mounting brackets.
3. Fit the pin to the front position (B) of the arm and bracket.
4. Fasten with R clips.
5. Start the engine and lift the deck into the cross cut
position, stop the engine and remove the ignition key.
6. Fit the rear pins and R clips in the holes (C) for the height
of cut needed.
7. Start the engine and lower the deck to the ground.
Wing Deck Height of Cut Assembly
1. Fit the Rear HOC Locking Plate (9) and go through the
elongated slot from inside the deck shell. Make sure deck
is lifted and support as required.
2. Install the serrated plate (7) on the welded bolts, fasten in
position with two M8 nuts (15).
3. Fit the Rear HOC Cover Plate (14) on to Rear HOC
Locking Plate (9).
NOTE
For height of cut adjustments see section 7.6.
B
C
A
C
C
B
B
7
9
15