en-26
5 CONTROLS AND DISPLAYS
5.2.Z.1
VISUAL DISPLAY __________________________________________________
The visual display is activated when the ignition is turned on.
5.2.Z.2
STARTUP SCREEN ________________________________________________
When the ignition key is turned to the start position, this screen is shown.
The hour meter will show total hours of engine operation.
5.2.Z.3
WARNING / SERVICE SCREEN ______________________________________
After the startup screen the warning screen is shown, the
screen is visible for four seconds. If the machine is within 5
hours of the next service, a warning is shown. An operator
input is needed to continue to the main screen. If there is no
input needed, the main screen will become visible. If a fault
condition has occurred during the previous start
,
a pop up
screen will become visible over the top of the warning screen.
The operator must confirm the fault before they can move to
the main screen.
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should read
the entire operators manual before attempting
to set up, operate, adjust or service the
machine.
TST
™
12 : 34 : 56
0.0 Hours
TST
™
A
M
1
2
3
10
11
12
13
14
15
16
17
18
19
4
5
8
7
6
TST
™
9
ICONS
1.
Parking Brake Engaged
2.
Deck Lock
3.
Cruise Control
4.
DPF Regeneration Request / Cancel
5.
DPF Regeneration Ongoing
6.
TST Active
7
TST Not Active
8.
Cutter Indicator (Flashes if not in off position on start up)
9.
Water In Fuel Warning
10.
Creep Mode
11.
Automatic Mode
12.
Manual Mode
13.
Foot Pedal Warning (Flashes if not in neutral position on start up)
14.
Seat Warning (Flashes if not occupied or disconnected on start up)
15.
Fuel Indicator (Below bar graph)
16.
Engine Temperature Indicator (Below bar graph)
17.
Time
18.
Engine Able To Start
19.
Engine Unable To Start
0.0 Hours
Содержание 070544
