Textron 070544, Инструкция по безопасности, эксплуатации и техническому обслуживанию/Список запасных частей

Страница: 58 / 134

en-58
6 OPERATION
6.10 TO REMOVE BLOCKAGES FROM CUTTING UNITS ______________________________
To remove A blockage from cutting units
1.Stop and lift the cutter decks before you move the machine to level ground.
2. Engage the transport locks.
3. Turn off the engine and remove the ignition key.
4. If the front cutter deck has become blocked, you will need to tilt front cutter deck refer to section 8.19
5. Wear the personal protective equipment that is applicable for this work, for example eye protection,
gloves and correct footwear. Use Bat (4184540), to remove the blockage.
6. Check the blades for damage and replace if necessary.
7. Disengage the transport locks.
8. Put the deck into the position for operation.
9. Start the engine and run the cutter decks to check for correct operation.
WARNING
Always use the Bat (4184540) and heavy duty leather gloves to clean under cutter deck to reduce the risk
of injury and infection from foreign objects.