EN
Operation and Storage Manual of Panel Heater
3
English
• Insert plastic dowels into the holes.
• Screw the screws into the dowels, and let them be submitted at least 5 mm.
• Attach the unit on the screws.
• Move slightly to the left of the appliance and then lower the down to make
sure that the screws are right at the top of the channels.
Second installation option:
• Place the enclosed mounting template on the box, drill the holes on the
top flap of the box, marked with +, in the direction shown in the figure
below.
• Open the box and place it on the wall as shown in the figure below.
Transfer the marked holes to the wall.
BATHROOM OPERATION
• The panel heater must be installed in accordance with the normal trade
practices and in compliance with the national legislation (EU electricity
directives and regulations concerning special installations and places of
operation including bathrooms, shower cabins HD60364-7-701(IEC 60364-
7-701:2006)).
•
In case this panel heater is to be used in a bathroom or other similar room,
the following installation requirements must be observed: the panel heater
is with IP24 protection (water drops protection). Hence it can be installed in
“Volume 2” (see the diagram below) in order to avoid the risk of the control
board (power switch and thermo regulator) being reached by a person who
is in a shower or a bathtub. The minimum distance between the appliance
and a water source should be not less than 1 meter and it is compulsory the
appliance to be wall-mounted! If you do not feel sure about the installation
of this panel heater in a bathroom, we recommend you to consult a
professional electrician.
Note
: If the above-mentioned instructions cannot be implemented, it is
recommended to install the appliance in “VOLUME 3”.
• In wet premises the power source must be installed at a height of at least
25 cm above the floor (bathrooms and kitchens).
•
The installation must be equipped with a safety fuse, and the distance
between the fuse contacts in disconnected condition should be at least 3 mm.
Thank you for choosing CN06 panel heater. This is a product providing
heating in winter depending on the consumers’ needs for comfortable room
temperature. If operated and taken care of properly in accordance with these
instructions, the appliance will provide you with many years of useful operation.
OPERATION INSTRUCTIONS
• Hold for 1.5 sec
ON/OFF
button for OFF or ON the heater.
•
Step back
– push the ON/OFF
button until 1 seconds
•
Quick menu/Confirmation
- push the Mode button
until 1 seconds
•
Full menu
- hold the Mode button
over 3 seconds
1. Predefined functions:
Comfort mode
; Eco mode
; Sleep mode
1.1. Comfort mode
-
with On/Off option - allows the user to set a desired
temperature when being at home. After once set it and the function is
switched On, the appliance will keep the same room temperature each time of
usage. This temperature to be set at 23°C by default.
Activation of „Comfort mode“
:
- Push the button “Mode”
for 3 sec and select “Comfort mode”
by
pushing any of the buttons:
and
and confirm with “Mode” button
