Tessonics RSWA, Руководство пользователя

Страница: 41 / 53

41 41
41 41
Chapter 5 Array Explorer Inspections
35
Figure 5.6 Information and inspection data areas
5.10 Inspections
An Inspection is a group of measurements. (For example, all the welds inspected on one
body part). Inspections allow the RSWA to organize and sort measurements for storage and
future review, and eliminates the hassle of users saving measurements on their own. e
Inspection area is only shown if you are currently in an Inspection.
ere are two types of Inspections available to choose from: Part inspection and Custom
Inspection.
5.10.1 Custom Inspection
e Custom Inspection type allows you to measure welds and assign names to these welds
as you check them. A screen shot of a Custom Inspection can be seen in Figure 5.7.
Weld Name – Shows the welds name. e default names are numbered welds starting from
one. Welds can be renamed individually by holding your finger on the weld until the
pop-up menu appears (approximately 2 seconds) and then selecting Rename. ere is
also an advanced Auto-Generator feature, see Section 5.10.1.3 on page 38 for informa-
tion.
Measurement umbnails – Each of these thumbnails represents a welds measurement.
Clicking on a thumbnail brings the measurement back into the C-Scan for review, along