Copyright Tes Drying Systems, 2014
23
Heater Operation Procedure
Knowledge of the proper operation of the
heater and heat exchange system is required for safe operation and to
keep heater and components operating properly.
1)
Read and understand the Remote Probe connection procedures and Menu Navigation in
SECTION #2
before proceeding with set-up and operation.
2)
Place the E-TES SD unit as required for your drying situation.
(SEE SET-UP SECTION #2)
3)
Connect Remote Sensors as needed, place Remote
Sensors in desired locations.
4)
Connect the two GFCI E-TES power cords to two
different 120volt outlets. If you have a 20amp circuit
one air mover should be able to be plugged into the
same circuit as one GFCI E-TES SD power cord.
Check the circuit breakers and the amp draw of your
air mover to determine if the circuit can handle the
load. If you are unsure, plug the air movers into an
outlet on a third circuit.
Section
3
Connect Remote Sensors here
CHECK CIRCUIT BREAKERS
TO
DETERMINE THE
AMPERAGE CAPACITY FOR
EACH CIRCUIT
USE CIRCUIT ANALYZER
TO CHECK CIRCUIT LOAD
For more information on the capabilities and use of the AC128 Circuit Analyzer, see the Circuit
Analyzer operator’s manual
PLUG CORDS INTO TWO
OUTLETS ON TWO
SEPARATE
CIRCUITS
