Copyright Tes Drying Systems, 2014
19
SOFTWARE UPDATES:
The
E-TES
SD
software
can
be
reprogrammed or updated using a removable
data storage device such as an USB Flash
Drive or Memory Stick. When software
updates are available you will be contacted by
your distributor. You will receive a Flash
Drive preloaded with the new software or the
software can be e-mailed to you to be
downloaded onto your own Flash Drive or
Memory Stick.
To update the E-TES SD software, with the
E-TES SD OFF, simply plug the memory
devise, with the E-TES SD software file, into
USB port on front panel. Push and hold both
the UP & DOWN buttons as you turn the E-
TES SD Power switch ON. The software will
automatically be updated. The display will read
UPDATE along with the old version and new
version numbers. The screen will not change
until the update is complete.
Then remove the memory device and turn the
switch off.
REMOVABLE USB
MEMORY DEVICE
Computer Serial Port for E-TES SD
manufacturer use only, used for testing
and formatting of microprocessor
SOFTWARE UPDATE SCREEN
Shows the old software version number and the
version number of the new software which is
replacing the old version
If your USB Flash Drive is protected by a password, you will need to
temporarily disable the password to connect it to the E-TES SD. This goes
for installing the activation key, installing updates, and downloading the job
data.
From our tests it was not necessary to disable the Flash Drive’s auto-run
programs, such as the SanDisk U3 Launchpad to work with the E-TES SD.
