70
To correct, do the following:
Sensor temperature = 24°C
(The measured temperature may be different due to the
location of the thermostat in the room).
Decrease the temperature measured by the ambient
temperature sensor by 2°C by pressing
. In our
example the measured temperature by the sensor goes
from 24°C to 22°C.
②
If the room temperature difference is positive.
Example :
Setting temperature (expected) = 21°C.
Ambient temperature (reading on a reliable thermom-
eter) = 23°C.
Difference measured = +2 °C.
To correct, do the following:
Sensor temperature= 21°C.
(The measured temperature may be different due to the
location of the thermostat in the room).
Increase the temperature measured by the ambient tem-
perature sensor by 2°C by pressing
. In our example
the measured temperature by the sensor goes from 21°C
to 23°C.
To validate the new value press
. To exit the Expert
settings, press
3 times.
THE RESET TO ZERO OF THE SENSOR
CALIBRATION
To put the value of the correction to «0», do the following :
①
When the temperature measured by the sensor appears,
press
or
for at least 3 seconds.
3 sec.
②
To save and move automatically to the next setting
press
. To exit the Expert settings, press
3 times.
Important:
These changes should be made by
a qualified installer during the first installation
SETTING THE POWER
To adapt the controller to the radiator and be able to
correctly estimate energy consumption, it is necessary
to set the power of the device.
①
Preset value: 500 W. Select a value between 300 W and
1500 W by pressing
or
. (Find the power of
the installed heating cartridge on the radiator packaging
or on the sales document.).
Содержание WEBL1K906F
Страница 41: ...41 EN ...
Страница 78: ......
Страница 79: ......
Страница 80: ...TERMA Sp z o o Czaple 100 80 298 Gdańsk Poland terma termagroup pl www termagroup pl 20200529WOLKA MPGKE 385 ...