Terex TS14G, Руководство по обслуживанию

Страница: 38 / 376

Section 110-0030
Engine - Engine and Mounting
SM 2274 03-04
12
1. Close shut off valves at coolant filter (3) inlet and
outlet lines and, using filter wrench, remove and
discard coolant filter (3) from engine (1).
2. Clean the filter adaptor with a clean, lint free cloth.
3. Lightly coat new coolant filter (3) seal with clean
engine oil as specified in Section 300-0020,
LUBRICATION SYSTEM.
4. Start coolant filter (3) on the filter adaptor and tighten
it by hand until the seal touches the adaptor filter head.
Tighten an additional 2/3 of a turn after contact.
Note: Mechanical tightening of coolant filter (3) is not
necessary and will distort or crack the adaptor. Tighten
oil filters by hand only.
5. Open shut off valves at coolant filter (3) inlet and
outlet lines.
6. Start the engine and check for leaks. If any leaks are
noted, have them corrected. Add coolant as required.
Refer to Section 300-0020, LUBRICATION SYSTEM .
4. Start a new oil filter (2) on the filter adaptor and
tighten it by hand until the seal touches the adaptor
filter head. Tighten an additional 2/3 of a turn after
contact.
Note: Mechanical tightening of oil filter (2) is not
necessary and will distort or crack the adaptor. Tighten
oil filters by hand only.
5. Start and run the engine for a short period and check
for oil leaks. If any leaks are noted, have them
corrected.
6. After the engine has been stopped long enough
(approximately 20 minutes) for the oil from various
parts of engine (1) to drain back to the crankcase,
check oil level and add oil to bring it to the proper level
on the dipstick. Refer to Section 300-0020,
LUBRICATION SYSTEM for oil specification.
Fuel Filter (4): Replace fuel filter (4) as follows:
Note:
There is a fuel system shut off valve on the
discharge side of fuel filter (4). Closing this valve will
prevent loss of fuel prime at time of filter replacement.
1. Close shut off valve at fuel filter (4) and, using filter
wrench, remove and discard fuel filter (4) from engine
(1).
2. Fill the replacement filter and coat the gasket
slightly with clean fuel oil as specified in
Section 300-0020, LUBRICATION SYSTEM.
3. Start new fuel filter (4) on the filter adaptor and
tighten it by hand until the gasket contacts the adaptor
fully with no side movement of the filter evident.
Tighten an additional 1/2 of a turn.
Note:
Mechanical tightening of fuel filters (4) is not
recommended, and may result in seal and/or cartridge
damage. Tighten fuel filter by hand only.
4. Start the engine and check for leaks. If any leaks
are noted, have them corrected.
Coolant Filter (3): Check condition of coolant inhibitor
as described in Engine 'Operation and Maintenance
Manual'. Replace coolant filter (3) as follows:
Note:
There is a shut off valve at the coolant inlet and
outlet lines of coolant filter (3). Closing these valves
will enable coolant filter (3) to be replaced without an
excessive loss of coolant.
Courtesy of Machine.Market