Terex TS14G, Руководство по обслуживанию

Страница: 237 / 376

Section 235-0050
SM 1739 2-99
5
Bowl Hydraulic System - Triple Pump
Fig. 16 - Removing Spacer
Fig. 13 - Removing Driveshaft
SM - 348
SM - 349
Fig. 14 - Removing Thrust Plate
SM - 350
Fig. 15 - Removing Snap Ring
SM - 351
Fig. 18 - Removing Seal From Retainer
Fig. 17 - Removing Seal Retainer
SM - 352
SM - 353
8. Repeat Steps 4 through 7 to remove gear housing
(22), matched gear set (20 & 21), bearing carrier (18)
and connecting shaft (17).
9. Separate and lift off gear housing (15) with care.
See Fig. 12. Remove thrust plate (11) as in Step 4.
10. Mark three meshed gear teeth with a dab of Prussian
blue, or similar dye, and remove matched driveshaft and
gear (12) and driven gear (13) set. See Fig. 13.
11. Pry thrust plate (11) from shaft end cover (6)
carefully to avoid distortion. See Fig. 14.
12. Clamp shaft end cover (6) in vice, mounting face up.
Remove snap ring (1) with snap ring pliers. See Fig. 15.
13. Pull spacer (2) from shaft end cover (6) with a
bearing puller. See Fig. 16.
14. Remove seal retainer (3) and seal (5) from shaft
end cover (6). See Fig. 17. The seal retainer removal
tool can be fabricated as shown in Fig. 37. Remove
and discard 'O' ring (4).
15. Tap seal (5) from seal retainer (3). See Fig. 18.
The tool shown in Fig. 37 can be fabricated to
separate these parts.
Courtesy of Machine.Market