6.
Installation
Please follow the steps below for proper installation :
1.
Mount the controller in a dry and ventilated place.
2.
Connect the Ethernet port to a 10/100 Base T Ethernet connection. For direct
connection to a PC use a “crossover” cable.
3.
Connect the I/O pins of the controller according to the required application.
4.
Connect the power supply.
If the Power LED is blinking, it indicates that the power supply is OK. By default
TCW110
comes with the following network settings:
IP:192.168.1.2 , Subnet Mask: 255.255.255.0 , Default Gateway: 192.168.1.1
Communication with
TCW110
may be established by assigning a temporary IP address to
your computer that is on the same network (for example 192.168.1.5). To get access to the web
interface of the controller, you should type the following URL into the browser :
http://192.168.1.2
. If the network settings are correct, the “Login” page will appear.
7.
Web-based setup
The web interface allows the
TCW110
to be configured, controlled and monitored via web
browser. Recommended programs are Mozilla Firefox, Chrome and Internet Explorer 6 (or higher
version) at 1024x768 resolution.
7.1
Login page
After opening the Login page, authorization data must be entered ( by default
username=admin , password=admin). It is recommended to change the username and password
to prevent unauthorized access to the controller.
Depending on the username and password, there are two access levels to the controller -
user and administrator. This is done to restrict the access to certain functions. Both access levels
are described in table below :
administrator
user
Account Administration
Monitoring
Network Setup
I/O Setup
SNMP Setup
