Teracom TCW110, Руководство пользователя

Страница: 8 / 12

7.5 SNMP Setup page
TCW110 supports SNMP v.1 that enables trap delivery to an SNMP management
application. This enables the device to be part of large monitoring and control networks. The
possible settings are:
•
SNMP Configuration – enable SNMP v.1
•
Read-Write community – performs client authentication
•
Read-Only community – performs client authentication
SNMP trap messages are sent for the following conditions:
- when event occurs on Digital Input 1 (the signal changes its state)
- measured voltage on Analog Input 1 is outside the predefined range
- measured temperature Is outside the predefined range
- restart
Setting range for sending SNMP trap messages is done only through SNMP. The following
parameters can be changed:
•
SNMP Traps – enable SNMP trap messages
•
IP address – IP address of the receiving host
•
Community string – performs client authentication
•
Trap Interval - time interval for SNMP trap messages
•
Max. number of Traps –
maximum number of SNMP trap messages sent, if trap
condition is present