TEPLOSTAR Binar-5B-Compact, Руководство пользователя

Страница: 65 / 74

Binar-5B/5D-Compact ENG
7 Installation specification for pre-heater and its assemblies.
7.1 General.
7.1.1. Heater shall be located lower the radiator overflow tank. Motor pump shall
be installed lower the radiator overflow tank and the heater.
7.1.2. Check up fluid flow in the heater and the engine cooling system; be sure it
has the same direction.
7.1.3. Remove air blocks from the engine cooling system and the heater on
completion of the heater installation. All the pipe junctions shall be leak-proof.
7.1.4. Fuel and coolant pipes shall be assembled in a way avoiding their contact
with hot or vibrating components of the vehicle.
7.1.5. It is unacceptable to operate the pre-heater with the cooling fluid frozen.
7.1.6. On completion of any activities with the cooling system (repair work,
cooling fluid replacement) it shall be purged to remove air blocks as per
7.2.Installation of the pre-heater units and assemblies.
7.2.1 Installation of the heater.
The heater shall be installed under
the bonnet as shown in figure 7.1. It is
unacceptable to install the heater on the
engine, passenger compartment or cab
of a vehicle.
The heater shall be installed with
account of its operating positions
(figure 7.2, items 7.1.1 and 7.1.2).
Seif-tapptng screw
Figure 7 .1 a - Mounting bracket
Fuel pipe
C oolunt circulation
E xhaust aas
1. H e a te r;
2. P a rk in g h e ate r;
3. C o n tro l p a n e l;
4. M o to r p u m p ;
5. E x h a u s t p ip e ;
6. F u e l p ip e ;
7. F u e l p u m p ;
8. F u e l in ta k e ;
9. A ir in ta k e ;
10. F u e l ta n k
Figure 7.1 - Pre-heater installation diagram
27