TEPLOSTAR Binar-5B-Compact, Руководство пользователя

Страница: 63 / 74

Binar-5B/5D-Compact ENG
Type of the transmitter has no significant meaning, the only requirement is that the
relay current consumption must not exceed current capacity of the remote alarm system
channel.
Connector XS4 which is connected with the harness is used for modem connection.
The harness XP4 must be disconnected from the control unit and connected with modem.
Simultaneous use of modem and remote control system is impossible!
A tten tion ! Heater operating time at start from remote control will correspond
to time established on the control panel, if time didn't change after connection of a
heater to the power supply by means of the control panel, the heater will work 40
minutes.
6.3 Use and install the modem to run the heater.
Operation of the heater can be operated by telephone.
For remote control operation of the heater is possible to connect to the control unit
GSM modem, which in essence is an analog cell phone without a display and keyboard,
designed for use in harsh conditions (cold, vibration, etc.). In modem, like the phone,
SIM card is installed, ie Heater gets a full phone number you selected service provider.
On account of this phone should be a small amount, so that the modem can send
SMS to you in response to a status request.
IMPORTANT! To operate the device in the SIM card PIN code to cancel, you iust need
to insert it in any cell phone and cancel a PIN code.
Heater control by means of a call to the modem, and enter commands voice menu.
When dialing the modem two possible situations.
1) The incoming phone number is not known to the modem. You will need to enter
the password (last 4 digits of IMEI). When done, you will see the commands for working
with pre-heater. If the password is entered in error, the modem will ask for the password
again. Password numbers needed administered slowly, at a transmission-reception digit
requires less than 0.5 seconds.
2) The incoming phone number is known modem. In this case, the commands for
working with pre-heater will be available immediately after the modem answers the call.
That number to be known, and did not need a password, it should be in the phone's
SIM-card in the modem, one of the first five memory cells. This can be done inserting the
modem SIM-card in the phone, clear the phone book (to the first cells were guaranteed to
empty) and record trusted phones. Trusted phones can not be more than 5.
The fact that the modem is ready to accept commands it is known by «type
command».
Commands are entered by pressing the number keys on the phone keypad.
25