OPERATION
EZ Rider 330730 (12--00)
12
SCRUB SWITCH
The
scrub switch
controls the scrub head, scrub
brushes, squeegee, and vacuum fan. The
scrub
switch
is also used to set the scrub brush
pressure.
Start scrubbing: Press the
scrub switch
. The
pressure indicator light will illuminate, the
squeegee will lower, and the vacuum fan will start.
The scrubbing system and solution flow will start
when the directional pedal is pressed and the
machine begins to move forward.
Stop scrubbing: Press the
scrub switch
. The
pressure indicator light will go out. The scrub
brushes will stop, the scrub head will raise, and
the solution flow will stop. After a short delay, the
rear squeegee will automatically raise. After
another delay, the vacuum will stop.
The brush down pressure indicators display the
pressure selection. The brush pressure indicator
has three positions. Brush pressure increases as
the indicator light moves to the right across the
display. Travel speed and floor conditions will
affect the scrubbing performance. Under normal
conditions, the brush pressure should be set in
one of the minimum settings. Set the brush
pressure in the maximum setting to scrub a
heavily soiled floor.
Change brush pressure: Press and hold the
scrub switch
. The pressure indicator light will
cycle through the three brush pressure settings.
When the switch is pressed and held, the brush
pressure will increase until it reaches the
maximum setting. The pressure will then return to
the minimum setting. Release the
scrub switch
when the desired setting is indicated on the
display.
NOTE: When the machine power is turned off, the
brush pressure will remain in the last setting used.
New & Reconditioned Equipment & Parts - www.southeasternequipment.net
