Tennant 186, Руководство оператора

Страница: 25 / 88

OPERATION
2Ć13
186 MM159 (6–94)
POST OPERATION CHECKLIST – ENGINE
STOPPED
Check skirts for damage, wear, and adjustment.
Check for wire or string tangled on brushes.
Check to make sure LPG tank service valve is
closed.
Check for LPG odor or frost on LPG hoses and
components, indicating a leak.
Check for leaks.
NORMAL SCRUBBING OPERATION
A normal scrubbing operation consists of seven
typical operations: pre-start checklist, starting
machine, scrubbing, draining recovery tank and
emptying debris tray, post operation checklist –
engine operating, stopping machine, and post
operation checklist – engine stopped.
PRE-START CHECKLIST lists things to check
before starting the machine.
TO START MACHINE lists the steps required to
start the machine.
TO SCRUB lists things to keep in mind before and
during the scrubbing operation.
TO DRAIN RECOVERY TANK AND EMPTY
DEBRIS TRAY lists the steps required to empty
the debris tray and the recovery tank.
POST OPERATION CHECKLIST – ENGINE
OPERATING lists things to check before stopping
the machine engine.
TO STOP MACHINE lists the steps required to
stop the machine.
POST OPERATION CHECKLIST – ENGINE
STOPPED lists things to check after stopping the
machine engine.
PRE-START CHECKLIST
Check under machine for leak spots.
Check engine lubricating oil level.
Check fuel level.
Check for LPG odor or frosting on hoses or
components indicating LPG fuel leak.
Check brakes and controls for proper operation.
Check service records to determine service
requirements.
TO START MACHINE
NOTE: Before starting machine, perform the
pre-start checks.
1. LPG powered machines: Slowly open the
liquid service valve.
NOTE: Opening the service valve too quickly may
cause the service valve check valve to stop the
flow of LPG fuel. If the check valve stops the flow
of fuel, close the valve, wait a few seconds, and
slowly open the valve once again.
2. Gasoline powered machines: When the
engine is cold, pull the choke knob out. Push
choke in after the engine has started and is
running smoothly.
LPG powered machines: When the engine is
cold and exposed to cold temperatures,
press the primer button on the LPG
vaporizer through the hole in the left engine
compartment cover.
3. Turn the on-off switch key to the right.
4. Push the start switch until the engine starts.
Do not operate the starter for more than 10
seconds at a time or after the engine has
started.
NOTE: Do not operate the starter motor for more
than 10 seconds at a time or after the engine has
started. Allow the starter to cool between starting
attempts. The starter motor may be damaged if it
is operated incorrectly.
5. Release the machine parking brake.
6. Drive the machine to the area to be
scrubbed.