To avoid damage to the Meter or to the equipment
under test, disconnect circuit power and discharge all
high-voltage capacitors before measuring capacitance.
Warning
The Meter’s capacitance ranges are: 2nF, 20nF, 200nF,
2µF, 20µF, 200µF and 600µF.
To measure capacitance, connect the Meter as follows:
Set the rotary switch to
F
measurement mode. If the
value of capacitor to be measured is unknown, use the
maximum measurement position 600µF and decrease
the range step by step until a satisfactory reading is
obtained and the overload icon "1" is not showing.
Insert the red test clip into the
CAP +
terminal and black
test clip into the
CAP –
terminal. For small value
capacitor measurement, insert the capacitor into the
small value jack.
When testing polarized capacitors, use the red test clip
on the capacitor’s positive lead, and the black test clip
on the capacitor’s negative lead. With non-polarized
c a p a c i t o r s , e i t h e r d i r e c t i o n i s a c c e p t a b l e .
The measured value shows on the display.
1.
2.
3.
4.
Model 72-8155: OPERATING MANUAL
15
C. Capacitance Measurement
(72-8155 only, see figure 5)
(figure 5)
Содержание 72-8155
Страница 2: ...Model 72 8155 OPERATING MANUAL 2 ...