Snappi System User Manual
Document No: 053-05 v29
Page 49 of 75
December 2015
Snappi System User Manual.doc
6.5: Rain Cover – not suitable for rearward facing Snappi
This is the recommended rain cover if you
need to use back recline and a rain cover at
the same time.
To fit the rain cover:
Attach the 4 push-on clips to the upper
frame of the pushchair, with the open clip
section pointing downwards.
The lower clip fits directly above the nylon
locking slider, while the upper clip attaches
to the upper frame tube.
Feed the open flap of material around the
rear frame, inside the push handles.
Next fold the cover down, and secure the
bottom using the 2 elastic ‘C’ clips.
Finally, join the rear flap of material to the
sides of the rain cover with the Velcro tabs.
To fold the cover back when not needed,
simply unhook the 2 elastic ‘C’ clips and fold
back. The cover can be secured in the open
position by attaching the C clips to the
upper frame.
Fig 6.5.1
Important:
•
The cover is for outdoor use only.
•
The cover must be folded back if the child remains in the pushchair when taken
indoors. Otherwise the child may overheat. The cover must also be folded back in
warm sunny weather.
•
Ensure your child’s fingers are clear of the frame when folding the rain cover back,
as the scissor action of the cover frame can trap small fingers.
•
The rain cover must be completely removed before folding the wheelbase.
•
The rain cover must be removed when using the pushchair as a seat in a motor
vehicle.
•
If you are fitting a rain cover as well as the frame padding, it is important that you fit
the rain cover to the pushchair first and then fit the frame padding round it. Finally
join the rear flap of material to the sides of the rain cover with the Velcro tabs.
