10
10
power without entering the PIN, perform the steps below.
1 From the Program Menu, press
9
2 You will hear the current setting. Default is “off”, the status mes-
sage will not be broadcast before the PIN has been entered.
3 You will hear “
Press one to change.”
4 Press
1
if you wish to activate the Status Message before PIN
5 You will hear the new setting. “On” will cause the monitor to
broadcast the Status Message Before PIN Entry.
6 You will be automatically returned to the Program Menu
Fahrenheit or Celsius Temperature Readings
The monitor can report the temperature in Fahrenheit (default) or Cel-
sius. To switch to Celsius, perform the steps below.
1 From the Program Menu, press
*
2 You will hear the current setting. Default is “C off”, the tempera-
ture is being output in degrees Fahrenheit.
3 You will hear “
Press one to change.”
4 Press
1
if you wish to change the Temperature Readout Mode and
have the temperature output in Celsius.
5 You will hear the new setting, “C on”.
6 You will be automatically returned to the Program Menu
Where to Locate the Monitor
The monitor measures temperature and power wherever it is located.
If the monitor is being used to protect against freezing temperatures,
locate it in an area where the temperature will drop the fastest, if the
heating system fails, such as a room with a northern exposure or nu-
merous windows.
If the monitor is being used to protect equipment against overheating
in case air conditioning fails, locate the monitor close to the equipment
and close to the ceiling where heat will build up quickest.
Once the location is chosen, connect the phone line and power. Turn
on the power switch (the light next to the phone line will start blinking
at a rate proportional to the temperature). Follow the instructions in
the Programming section.
What happens when the Monitor calls?
1 The monitor will play the personal identification message, followed
by the cause of the alarm.
2 The monitor will ask for the PIN number
3 Once the PIN number has been entered, the monitor will not call
again because the current alarm condition has been acknowl-
