30
31
Mold Test will guide that user can check the status of system and investi-
gate the problem.
1. Select [Mold File] Menu on the [Main Page].
2. Select [Mold Test] Button on the [Mold File].
3. Select test that needs to be investigated and select the next zone for
test.
4. When you start [Start] Button, test will start.
* When you find the problem, it will be useful if you refer to [Problem and
how to handle the problem while you are using the controller] and [Error
Code Table] on Chapter 13.
7.4.2. Mold Test
① Wire Test:
You can test wiring Test, T/C, open/Short Circuit/reverse connec-
tion for heater wiring and so on.
② T/C Test:
open/Short Circuit/ reverse connection Test for T/C.
③ Heater Test:
open/Short Circuit Test for heater
④ Start:
When you click the Button, screen will be changed to Test Screen and
test will start.
⑤
Selection Button for Test Zone:
You can choose the zone to test selectively.
①
②
③
④
⑤
7.4.3. Run mold test
Test will progress when you click [Start] Button on [Mold Test] and Progress
Status will be displayed.
④
⑥
①
②
③
⑤
① Start Time:
It will display Start time of the Test.
② Progress Time:
It will display Progress of the Test.
③ Remaining time:
It will display forecast remain time until the end of test.
④ Finish Rate:
It will display finish rate of the test with 100%.
⑤ Finish:
Test will be finished when you click Finish Button whenever you want
to stop on the test.
⑥ Display of progress status:
It will display progress status of the test.
Содержание TC-3200 Lite
Страница 1: ...TC 3200 Lite Ver 1 1 ENG Instruction Manual...
Страница 23: ...44 45 11 2 380V 440V 3Phase 4 Line Type 11 3 240V 1 Phase 2 Line Type...
Страница 27: ...52 53...
Страница 28: ...54 55...