Tempcube TC-3200 Lite, Инструкция по эксплуатации

Страница: 14 / 29

26 27
⑥ Setup PID: You can set value of PID manually according to some Mold or
status of the heater.
⑦ K (Constant):
This is the value of constant to apply on calculation of PID.
⑧ P (proportion): This is the value to apply on calculation of amount of the
output about the gap of the setting temperature.
⑨ I (Integral):
This is the major value to get rid of the accumulation gap
around the setting temperature.
⑩ D (differential):
This is the major value to prevent from sudden change of
amount of the control.
7.3.2. System setting display
① Display of Decimal Point: You can set how to display of
[Current Temperature] on the [Active Screen].
Ex) Display of Decimal Point [Yes]: 200.0 ℃
Display of Decimal Point [No]: 200 ℃
② How to display the temperature: You can change the range of the using
temperature. [℃↔℉]
Ex) How to display the temperature [℃]: 200℃
How to display the temperature [℉]: 200℉
③ Stand By (Hour): It will turn to [Auto Mode] after the setting hour
on the Stand By Mode.
④ Stand By (Minute): It will turn to [Auto Mode] after the setting Minute
on the Stand By Mode.
System Setup is for the setting of the entire system. You can set when you
click [System Setup] on [Main Screen].
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬