Teltonika © 2010 All Rights Reserved 25 |
P a g e
3.7
Alarm Setting
3.7.1
Motion Detect
Area settings.
Hold
Ctrl
to select the area. Up to 4 zones are allowed. Click
Clear
to
delete zones.
Sensitivity.
Select level of sensitivity.
Valid Time.
Set up the time when motion detection is active.
Notify Client
. Send alarm message to DVS Client software on Motion Detection.
Trigger Record.
Enable recording to SD card on Motion Detection.
Send E-Mail. S
end alarm e-mail on Motion Detection.
Trigger Alarm Out
. Enable to trigger alarm output when motion is detected.
Note:
Set Valid Time to enable motion detection.
Figure 27.
Motion Detect Settings
3.7.2
AlarmIn
Configure camera’s actions when Alarm In is detected.
Channel Name.
Set channel name
Trigger level.
Choose trigger level:
Low:
n.c.
(normally closed) contact (alarm on opening contact)
High:
n.o.
(normally open) contact (alarm on closing contact)
Actions To Take.
Notify DVS Client, trigger record, send e-mail.
Trigger Alarm Out
. Enable to trigger alarm output.
Valid Time.
Set up time when alarm input is active.
