65
8.2.6
Ignition Source (ID=1004)
Ignition Source sets ignition triggered functionalities.
Parameter
ID
Value
0 (By Power Voltage – default)
1 (By Ignition Din1)
Ignition Source
1004
2 (By Movement sensor)
High Voltage Level*
1005
Min: 0, Max: 30000 (mV)
Low Voltage Level*
1006
Min: 0, Max: 30000 (mV)
* - used when External voltage selected as ignition source.
8.2.7
Ignition Detection(ID=1008)
This parameter defines ignition detection.
Manual – ignition detection is by parameters set by user(13-30V)
Automatic – ignition is detected by device:
Power voltage(12V) – ignition on 13.2 - 30
Power voltage (24V) – ignition on 27 – 30
Parameter
ID
Value
0 - Manual
Ignition Source
1008
1 - Automatic
8.2.8
Ignition Detection Timeout(ID=1009)
This parameter defines time, in which Power Voltage can be lower than set value.
For example, Power Voltage drops from 14V to 12V for 5 seconds(timeout is set to 10)
device will not detect “ignition off” state.
Minimum
value
Maximum
value
Recommended
value
Goes with (depends on)
parameters
Value
type
0
65535
10
U8
8.2.9
GNSS FIX Timeout for Time Synchronization via NTP (ID=1007)
If “GNSS FIX Timeout” is set too 60s (default value) and during this time GPS FIX is received
– use default (GNSS) time synchronization method. However if the GPS time FIX is not received:
a. FM is going to get time using NTP server. Device will activate GPRS context and create UDP
connection to destination port 123 using SNTP protocol.
Minimum
value
Maximum
value
Recommended
value
Goes with (depends on)
parameters
Value
type
0
65535
60
U8
Downloaded from
www.Manualslib.com
manuals search engine