Originating Calls
Wait For Delay Dial/Wink Start
Time before TSP initiates Delay Dial/Wink signaling at start call.
Wait For Delay Dial/Wink End
Time till TSP terminates Delay Dial/Wink signaling. For Wink Start, the timing defaults to .350
sec.
Delay Before Dial
The delay before the TSP starts transmitting digits for each call made by the TSP.
Wait for Answer
The time the TSP waits before abandoning a new call if there is no answer.
Terminating Calls
Delay Before Delay Dial/Wink Signal
Delay before the TSP sends Delay Dial/Wink signaling back once it detects Delay Dial/Wink from
equipment under test.
Delay Dial/Wink Length
Time till TSP terminates Delay Dial/Wink signaling response. For Wink Start, the timing defaults
to .250 secretary.
Delay Before Answer
The delay before the TSP sends an off-hook indication once it detects an off-hook from the
equipment under test.
Wait for Dialing Start
This only applies when the Template is used in a Dialed Control Set type. It’s the time the TSP
will wait for the first digits to be sent before timing out
Inter-digit Dial Timeout
This only applies when the Template is used in a Dialed Control Set type. It’s the time allowed
between the dialing of digits before the TSP will timeout on the call.
Delay Before Ringback
In a Dialed Control set, the delay from the dialing of the last digit of a valid Phone Number to
when the TSP starts to send Ringback. In other control sets, the delay from the end of dial tone to
when the TSP starts to send Ringback.
Ringback Length
Length of time the ringing cycle will be played by the TSP to the equipment under test.
All Calls
Delay Before Message
The delay before an audio file is played if one has been assigned to the channel. Does not apply
to End-to-End calls.
Call Duration/Disable Timeout
Controls the length of the call before the TSP starts a new call. Clicking on the box adjacent to
Disable Timeout will allow the call duration to be determined by when the TSP receives an
on-hook indication. Does not apply to End-to-End calls.
Far-End Disconnect Time
Time the TSP delays after receiving an on-hook from the equipment under test before it goes to
an on-hook state.
Disconnect To Start Of New Call
Time TSP delays after going on-hook before resetting for a new call.
Telecom Simulation Platform
Page 68
