Telpar MTP-600 Series, Руководство пользователя

Страница: 28 / 45

TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03) Page 22
Bit 4 --- 1 = MARK CHECK failed.
Bit 3 --- 1 = CUTTER error.
Bit 2 --- 1 = HEAD UP sensor.
Bit 1 --- Not used.
Bit 0 --- Not used.
The third byte:
Bit 7 --- Not used.
Bit 6 --- Not used.
Bit 5 --- Not used.
Bit 4 --- Not used.
Bit 3 --- Not used.
Bit 2 --- 1 = PAPER OUT.
Bit 1 --- Not used.
Bit 0 --- 1 = PAPER LOW.
The fourth byte is the parameter (
+n
) from command sequence FS r
+n
[1C 72
+n
] which was last processed out of the FIFO buffer.
4.2.7.7 Bar Code Command
GS k +m +n +d1 ∼ dn [1D 6B +m +n (DATA)]
+m
selects the bar code type.
+n
defines the number of data bytes
which follow.
m = 41hex = UPC-A n = 11 or 12
m = 43hex = JAN(EAN)13 n = 12
m = 44hex = JAN(EAN)8 n = 7 or 8
m = 45hex = CODE39 n is variable.
m = 46hex = ITF (Interleaved 2 of 5) n is variable.
m = 47hex = CODABAR. n is variable.
If more data is sent than can fit on the printer being used, the print will
start left justified and run off the sheet to the right. Any data exceeding
the page width will be lost.
4.3 Serial (RS-232C) Interface
4.3.1 Serial (RS-232C) Interface Specification
Serial (RS-232C) Interface Specification
Item Specification
Data receive speed 19200, 9600, 4800,1200 bps (set by DIP switch)
Synchronizing method Asynchronous, Full duplex
Hand shake DTR/DSR signal or XON/XOFF (set by DIP
switch)
Input output level RS-232C
Signal level
Space (logic=0) +3 V
∼
+12 V
Mark (logic=1) -3 V
∼
-12 V
Table 11 - Serial (RS-232C) Interface Specification