Telpar MTP-600 Series, Руководство пользователя

Страница: 26 / 45

TELPAR MTP-600 Receipt Thermal Printer User Manual
MTP-600 User Manual – Part No. 090102-0010 (Rev. B – 6/03) Page 20
4.2.7.4 Select Paper Type
ESC c 1 +n [1B 63 31 +n ]
+n
is defined as:
Bit 7 --- Not used.
Bit 6 --- Not used.
Bit 5 --- 0 = Forward detection of marks.
1 = Reverse detection of marks.
Bit 4 --- Not used.
Bit 3 --- Not used.
Bit 2 --- Not used.
Bit 1 --- 0 0 1 1
Bit 0 --- 0 1 0 1
= Continuous roll, auto load
enabled.
= Cut sheets.
= Labels, auto load to block,
mark enabled
= Continuous roll (default).
Default is 0. If there is data in the print buffer when this code is
received, the data is printed and then this command takes affect.
When cut sheets is selected, the cut sheets are automatically fed when
they are loaded into the printer (auto load). When the selection changes
from cut sheets to any other paper, an existing form will automatically
be ejected.
4.2.7.5 Status Commands
TRANSMISSION OF STATUS applies ONLY to the SERIAL
INTERFACE.
Three commands pertain to status transmission: FS 9
+n
, FS r
+n
, and
GS a
+n
.
GS a +n [1D 61 +n }
Causes the printer to transmit four status bytes on the XD line and also
sets the functions which will cause the printer to automatically transmit
the status bytes whenever an event occurs except that GS a NUL [1D
61 00] does not cause status to be transmitted. The default state on
+n
is 0 so that status is not automatically sent when an event occurs.
To POLL for status rather than have status sent requires a six character
sequence to be sent to the printer: GS a
+n
>NUL GS a NUL [1D 61 7F
1D 61 00]. The [1D 61 7F] causes status to be transmitted and the [1D
61 00] disables the automatic status transmission.
+n
is defined as:
Bit 7 --- Not used.
Bit 6 --- Not used.
Bit 5 --- Not used.
Bit 4 --- 1 enable AUTO STATUS when the AUTO PAPER
LOAD function is used.
Bit 3 --- Not used.