OLT6 and 1134 Description Installation and Turnup Guide
Page 42 of 50
AID of Uplink Interface
Accept the system default (NET1). A Link Aggregate Group (LAG) or uplink
interface can have the values NET1..NET12 on the OLT.
Number of Ports
The number of ports to be bundled in the uplink LAG. Up to eight(8) 1G ports or
four(4) 10G ports are allowed. Only uplinks of the same speed can be included in
a LAG.
Enable Link Aggregation Control Protocol
Link Aggregation Control Protocol (LACP) is the standard protocol used to
manage the ports in a LAG. The LACP configuration for a LAG must be consistent
between both participants(OLT and connected upstream switch). If only one side
has LACP enabled, the LAG will be disabled and traffic will not flow. LACP is
disabled by default.
Element Management Traffic Tagging
Select tagged(2) or untagged(1). It is recommended that management traffic be
tagged to isolate it from untagged user traffic. Mixing of management and user
traffic can pose a real security risk. Separating them ensures that users cannot
access the management interface. This setting must agree with the upstream
switch setting for the management VLAN.
VLAN ID for Element management Communication
This specifies the VLAN ID for management traffic between the OLT and
Panorama.
VLAN Priority
Defines the 802.3P layer 2 priority bits for management packets. It is
recommended that the default setting of 7 be used to ensure management traffic
continues to flow even if the link becomes oversubscribed.
IP Stack Type to use
Select the IP stack type to use for management traffic. The type selected must
agree with the Panorama configuration. IP stack can be configured for IPv4, IPv6,
or both. Both allows for both IPv4 and IPv6 access to the OLT for ssh, but the
EMS can only use a single stack type at a time (IPv4 or IPv6).
Address
Enter the IPv4 address to be used by the OLT.
Network Mask
Enter the network mask for the OLT.
Default Gateway
Enter the default gateway IP address to be used by the OLT.
·
When the Wizard finishes gathering data, a summary is displayed for
confirmation. To accept the configuration and perform the turnup, type
Y
at the
