Telkom ADSL 5102G, Быстрый старт

Страница: 11 / 20

Telkom ADSL 5102G
9
c) Your router will now attempt to synchronize with the Telkom ADSL line. The
“ADSL” LED will come on, start to blink and after approximately 1-2 minutes be
steadily lit. If the “ADSL” LED does not come on, please refer to the
troubleshooting section at the end of this guide.
d) The Telkom ADSL 5102G router is, by default, distributed with a guest ISP
username and password. This guest account allows you access to the
www.telkom.co.za website only. Although this account only allows limited
access, it serves as a tool to confirm that your hardware installation and your
own PC’s network configuration has been completed successfully. This guest
account will cause your router’s “PPP” LED to be steadily lit now. We will again
refer to this guest account at a later stage of the installation process.
3. Connect the LAN (network) cable
a) Plug one end of the enclosed Ethernet (CAT -5 LAN) cable into one of the
router’s LAN ports, you may choose any of the 4 ports (E) .
b) Plug the other end of the Ethernet (CAT-5 LAN) cable into your computer’s
network port or network hub/switch (F) .
c) Confirm that the corresponding LAN LED is lit.
d) You can connect up to 4 network devices directly to the Telkom ADSL 5102G
as shown in the overview sketch (F) .
4. Connect the ADSL micro filters
a) If you also intend to use traditional telephones (for voice calls) on the ADSL
line, you need to connect the included ADSL micro filters. (These units filter
out any data noise on your voice lines.)
b) Plug the micro filter into the Telkom wall-s ocket from where you intend to
utilize your traditional telephone (G) .
c) Plug the telephone into the micro filter (H)
E
F