WE866Cx Linux Companion RF Test User Guide
1VV0301640 Rev. 1
Page
23
of
34
2020-06-03
4.4.
QRCT WLAN Rx Test Procedure
Table 4-2, lists the Rx settings description.
Table 4-2 Rx Settings
To run the WLAN Rx Test procedure, perform the following steps:
1.
Click
RX
2.
Under
RX SETUP
, set the desired RX Setup in QRCT
3.
Click
SET CONT.RX
4.
Load the appropriate ABS waveform on VSG:
WLAN_11b_SHORT_RATE11_LEN1024.wv
5.
Enter the Cable loss, Frequency, and Power level.
6.
GPRF Generator ON
7.
Click
SET CONTINUOUS RX
and send a statistically significant number of packets
through VSG
8.
Click
GET RECEIVER REPORT
in the QRCT
9.
Continue incrementing the jammer power level until PER at a given power level
reaches the limits defined in the standards.
10.
Inspect receiver report and calculate PER.
