IP-223 to RTS Intercom Products
AN-DISPATCH-035
7
3.1.2
Crosspatch Setup Window
The
Crosspatch Setup
window, shown in Figure 4, is used to set up a crosspatch.
To
enable crosspatching
, do the following:
1. Click
CRP Setup
.
The Crosspatch Setup window appears.
2. Select the
Enable Line-Line
check box.
Crosspatching is enabled
.
3. Click
Submit
.
The Crosspatch Setup configuration is temporarily saved.
4. Click
Save to EEPROM
.
The EEPROM window appears.
5. Click
Save Parameters
.
All configurations are permanently saved to the IP-223 console.
3.1.3
Per Line Setup Window Line 1
The
Per Line Setup
window is used to configure per line setup. Line 1
configuration depends on the type of radio interface.
REFERENCE:
For more information about special configuration requirements on
Line 2 for the type of radio connected, see the IP-223 Technical
Manual (P/N 803641) or the appropriate application note.
FIGURE 4. Crosspatch Setup Window
