IP-223 to RTS Intercom Products
AN-DISPATCH-035
11
4.1.2
Crosspatch Setup Window
The
Crosspatch Setup
window, shown in Figure 4, is used to enable line-to-line
crosspatching.
To
enable a crosspatch for an iDEN radio
, do the following:
1. Click
CRP Setup
The Crosspatch Setup window appears.
2. Select the
Enable Line-Line
check box.
Crosspatching is enabled.
3. Click
Submit
.
The Crosspatch configuration is temporarily saved.
4. Click
Save to EEPROM
.
The EEPROM window appears.
5. Click
Save Parameters
.
All configurations are permanently saved to the IP-223 console.
4.1.3
Per-Line Setup Window Line 1
The
Per Line Setup
window for Line 1, shown in Figure 8, is used to setup LAM
and activate options such as F1 Last Call, Full Duplex, and RxACG.
The recommended LAM level is -25dB. However, the optimum level may vary
depending on the terminal attachment (iDEN handset). Handset volume is adjusted
to present clear receive audio and the LAM level is set to block unwanted noise. A
LAM time of three (3) seconds is recommended to avoid continual switching of
receive audio.
