LCD 63SE (VG) Keypad
User Manual
13
Disarming Both partitions A and B
Voice Messages in Disarming Mode
(LCD 63VG SE)
A continuous beep indicates the entrance time . The voice messages “
System is armed
” and “
Please,
enter your code to disarm
” will sound on every 5 seconds .
After a valid code has been entered, the message “
System is disarmed
” will be repeated twice .
If no valid code has been entered during entry time, the “
System is armed
” message will sound .
If an alarm has been triggered in the system, the messages “
Alarm in the system
” and “
Please, enter
your code to disarm
” will be repeated every 5 seconds .
Stopping the alarm
The alarm is stopped by entering a valid personal code with assigned rights to operate with both
Partitions in the system .
ATTEnTIon: If you cannot stop the alarm using a valid user with assigned rights to operate
with both partitions, call the Engineer and your system technical support!
panic Buttons
Press and hold the
+
buttons for 2 seconds, to send an alarm signal to the control panel .
The option not sounding the siren when using the panic buttons is programmed from the engineer .
Ambush Code
Ambush code is a personal code that disarms the system, but still sends alarm signal to a Central
monitoring station . Its purpose is to indicate that the user is forced to disarm the system against his
will .
The ambush code is produced from a personal code by increasing the last number by one . If the last
number is 9, it is replaced by 0 in the ambush code .
Example:
Personal code: 4615 → Ambush code: 4616
Personal code: 4619 → Ambush code: 4610
entry
time
code
Note:
To the user code are assigned rights to operate with
both Partitions A and B, otherwise the system will DISARM
only that Partition for which the User code are assigned
rights!
