Preparations
NB! Before starting the installation
please read the instruction carefully
When deciding on the best position for the control keep the
control lever movements in mind. Ensure full throttle
movement without obstruction at position chosen before
the hole is cut.
Also check that space required for installation is sufficient.
Installed from the outside the mechanism, seen in fig. 1 &
2, requires a distance of min. 200 mm from the hull to the
inner wall (see fig. 10 & 11). If installed from the inside a
distance of 100 mm is enough.
The mechanism with attaching plate (fig. 3) needs the least
space (appr. 100 mm) when installed from the outside.
The wall or mounting plate must not be thicker than 12
mm.
Fig. 1 & 2
B mechanism
A
Alternative gear cable holders
B
Gear lever
C
Gear cable connection for ± 38 mm travel
D
Gear cable connection for ± 31 mm travel
E
Adjustable brake
F
Neutral position knob
G
Throttle cable holder
H
Throttle lever
J
Screw
K
Washer
L
Attachment holes for neutral safety switch
Fig. 3 shows the mechanism with attachment plate. This
mechanism is used for controls with trim switch function.
2 (16)
