TeleEye JN308, Руководство пользователя

Страница: 42 / 80

34
Step 2: Select the Schedule tab. This will bring up the schedule setup interface. The setup steps for schedule for alarm out are
similar to normal schedule setup; you can refer to 4.4.1 Schedule for details.
This step is very important for alarm out. Even if you have enabled alarm out in the motion based alarm or sensor based alarm,
you will not see the result of alarm out if no schedule is added here.
Buzzer
It is an inbuilt alarm output device. To setup Buzzer: Fig 4-28 Alarm Out
Step1: Enter into Menu
Setup Alarm out Buzzer tab;
Step2: Checkmark Buzzer and set buzzer alarm hold time. This would trigger the
buzzer when the system is in alarm.
4.6 Network Configuration
Network configuration includes five submenus: network, sub stream, Email, server
and other settings. Network settings must be configured if DVR is used for
monitoring over network.
4.6.1 Network
Step 1: Enter into Menu Setup Network network tab. Refer to Fig4-29:
Step 2: HTTP port: the default value is 80. If the value changed, you need to
modify the IP address in the IE address .i.e. if HTTP port is set to 82 and IP
address is,
192.168.0.25 , then you shall input IP address as http://192.168.0.25:82
in IE browser.
Server port: Communication port. Fig 4-29 Network Configuration-Network
Step 3: Connect Internet. If you have a DHCP server running and would like your DVR to automatically obtain an IP address and
other network settings from that server, check the checkbox beside "Obtain an IP address automatically". Then the device will
distribute IP address, subnet mask, and gateway IP and DNS server. If you want to configure your own settings, please input the
IP address, Subnet mask, Gateway DNS server manually. You can also check the PPOE checkbox to enable this feature and
then enter username and password. Once the setup is completed, your DVR will automatically dial up into your network.