Teledyne Princeton Instruments PI-MAX 3, Системное руководство

Страница: 26 / 250

26 PI-MAX
®
3 System Manual Issue 2
2.1.6 Power
All voltages required by PI-MAX3 camera systems are generated and delivered by an
external power supply included with each PI-MAX3 camera using the supplied cables.
CAUTION!
!
Use of a power supply other than that provided with the
PI-MAX3 camera may severely and permanently damage the
camera and will void the camera warranty. For specific
power supply requirements, contact Teledyne Princeton
Instruments. Refer to
Contact Information on page 248 for
complete information.
The receptacle on the power supply should be compatible with the line-voltage line
cords in common use in the region to which the system is shipped. If the power supply
receptacle is incompatible, a compatible adapter should be installed on the line cord,
taking care to maintain the proper polarity to protect the equipment and assure user
safety.
AUX I/O 26-pin male DB connector. Provides access to the following five I/O
signals that can be used to input a trigger to initiate data acquisition, to
monitor frame readout status, and to control an external shutter:
• T
0
Out;
• Pre-Trigger In;
• SyncMASTER1;
• General Purpose Input 0;
• SyncMASTER2.
Refer to Section A.1.1, AUX I/O Connector Pinout , on page 201 for
additional information.
LOGIC OUT 0 to +3.3V logic level output (TTL-compatible).
WinView/WinSpec32 (Version 2.5.25 or higher) software-selectable
Acquiring, Image Shift, Logic 1, Read Out, Shutter, and Wait for Trigger
signal.
When the Invert LOGIC check box is checked, the output is at a logic low
when the action is occurring.
POWER 7-pin D specialty connector; connects to the PI-MAX3 external power
supply.
GIG-E Ethernet port.
AUX OUT DC-coupled variable delay trigger output for synchronizing other system
components with the PI-MAX3 internal timing generator.
The host software sets the Delay Time of this output with respect to the
internal timing generator trigger time.
The source impedance is approximately 100

and it will provide >1 V into
50

.
Table 2-1:
PI-MAX3
Rear-Panel Connectors and Indicators (Sheet 2 of 2)
Label Description