Teledyne Princeton Instruments NIRvana HS, Системное руководство, Страница: 37 / 107

Chapter 6 First Light 37
6.1 Imaging Applications
This section provides step-by-step instructions for acquiring an image in LightField for
the first time. The intent of this procedure is to help gain basic familiarity with the
operation of the system and to show that it is functioning properly. Once basic
familiarity has been established, then operation with other operating configurations,
ones with more complex timing modes, can be performed.
This procedure assumes:
• The system has been set up in accordance with the instructions in previous
chapters;
• Familiarity with LightField;
If this is not the case, refer to the online help while performing this procedure.
• The system is being operated in imaging mode.
• The target is a sharp image, text, or drawing that can be used to verify that the
camera is seeing and can be used to maximize focus.
Perform the following procedure to set up and configure the system to acquire an
image:
1. Mount a test target in front of the camera.
2. Turn on the NIRvana HS.
3. Turn on the host computer.
4. Launch LightField.
5. Once LightField has launched, a NIRvana HS camera icon will be shown in the
Available Devices area. See Figure 6-2 .
Figure 6-2: Typical Devices Tab: Imaging Application
6. Drag the NIRvana HS camera icon into the Experiment Devices area. See Figure 6-3 .
44
11-
0
16
9
_0
01
4