Teledyne 440, Системное руководство, Страница: 87 / 256

5 – Operating Software
DPN 402196 Issue 4.1 © Teledyne TSS 5- 21
Use the Altimeter Configuration Window to set appropriate parameters for your altimeter:
The Altimeter Configuration Window allows you to select an SDC serial communication port that you
will use to accept data from the altimeter and to set its communication parameters. Note that the 440
and 440 systems can have different offsets. Although a single altimeter is present, its height above the
440 and 440 coils will be different.
The altimeter test allows you to see the serial data transmitted by an altimeter connected to the SDC.
The values shown will not have any meaning until the altimeter is immersed in water.
Table 5-4: Altimeter configuration parameters
Parameter Options
Altimeter
❐ Disabled
❐ Fixed height
❐ Sub-sea TSS*
❐ PSA 900**
❐ PSA 900 + depth**
❐ PSA 9000**
❐ PSA 916*
❐ Ulvertech Bathy
❐ Simrad UK90
❐ OSEL Bathy
❐ SeaKing Bathy 704
❐ Hyspec 305
Altimeter
Comms
❐ Altimeter connected via Sub-sea Electronics Pod (for altimeters marked *
and ** above)
❐ Altimeter connected direct to a COM port (for altimeters marked ** and all
other altimeters above)
Fixed coil alti-
tude
If there is no altimeter fitted and the design of the ROV allows the coils to
remain at a fixed altitude above the seabed, enter this altitude in centimetres.
Altimeter off-
set
Enter the height difference, in centimetres, between the reference line of the
440 coil array and the transducer face of the altimeter.
Use a positive value if
the altimeter is above the coils.