Teledyne Analytical Instruments 3020 M, Руководство по эксплуатации

Страница: 59 / 107

Installation Model 3020M-ATEX
Teledyne Analytical Instruments 36
3.5 Temperature Controller Settings (0-1%
Analyzer only)
The 0-1% Sensor uses a PID Temperature Controller to control an
oven that surrounds the sensor. It has been set up at the factory for your
application. Nevertheless, it is possible to make changes to the thermal
environment if required however this should never be done without
contacting Teledyne Customer Service first. Other parameters will be
affected if the temperature setpoint or other feature is changed.
The following settings for the temperature controller have been set
at the factory:
Function Value Description
hPb 3.1 Heater proportional band setting
ti 455 Setting for time integral for the output
td 114 Setting for time derivative for the output
o.tb 1 1 Time base output. Sets the time base for fixed time
base control.
SEn R0.1H Sensor type used in the instrument. RTD 100
Ω
C_F C
dEC 0.00 Sets the display precision. (hundreths)
Fn1 heat Sets which function drives Output 1
h.Ag Pid Heat control method.
3.6 Testing the System
Before plugging the instrument into the power source:

Check the integrity and accuracy of the gas connections. Make sure
there are no leaks.

Check the integrity and accuracy of the electrical connections. Make
sure there are no exposed conductors

Check that sample pressure is between 3 and 25 psig, according to
the requirements of your process.