TelcoBridges Tmedia TMP800, Руководство по установке

Страница: 9 / 46

Introduction
3
1.2 Installation Prerequisites
In order for the TMP800 system installation to proceed without interruption, it is important that you verify
that you have on hand all of the necessary materials. Prior to beginning the installation, you should
have prepared for the following:
• Adequate space for the installation of your Tmedia system. Consider that you will need to mount
the TMP800 on a 19” customer-provided equipment rack.
• Adequate power supply and power connections. In order to guarantee an uninterrupted supply, the
TMP800 must be powered by a dedicated power source. Consider that a TMP800 will require one
power connection in addition to PCs, servers, and Ethernet switches.
• In order to run your telecom applications on the TMP800, you will need to have purchased an
adequate number of licenses for the features that you will use.
In addition, you will need the following equipment:
Gigabit Ethernet Switches
TelcoBridges recommends that the Tmedia Control Network be separated from the IP network;
therefore, it is recommended that you use one managed gigabit Ethernet switch usingVLAN to connect
the TMP800 to the networks, as shown in Section 1.2 “Recommended Network Setup” on page 3.
Depending on your current network setup, other configurations can be selected.
Figure 1.2 Recommended Network Setup
In its lab studies, TelcoBridges has not encountered any problems with a large variety of switches
available in the market. The following is a list of some switches that TelcoBridges has used:
• Dell Powerconnect 2708, 8 gigabit Ethernet ports
Tmedia Control
Network External VoIP
Networks
Server Router
Managed Ethernet Switch
TMP800
Tmedia Control Network IP Network
Control VLAN IP VLAN