GW-482S INSTALL ATION GUID E
12
MN100143 Rev B
Connecting Ethernet and Phone Cables
Installation Instructions for a Unit Supplied Without a Patch Panel
The user must connect the data and voice communication cables to the Port and Phone connectors
on the gateway board.
Use the following cable types for connecting data and voice communications:
•
For 10/100BaseT X ports, use shielded twisted pair 100 Ohm CAT 5 or sUTP CAT 5.
•
For phones, use standard DT MF telephone cables.
To connect the data and voice communication cables:
1.
Insert the cables through the ingress at the bottom of the unit. Push the cables in, one at a
time, through the small opening in the center of the rubber seal.
2.
Connect the Ethernet RJ-45 connectors to the 10/100BaseT /T X connectors of the
customers’ work-stations using a straight-through CAT 5 Ethernet cable.
3.
Connect DT MF telephones to the RJ-11 connectors. Up to 5 phones can be connected in
parallel to each RJ-11 connector.
4.
Plug in the AC connector.
Figure 16: LAN and PHONE Connectors on the Gateway Board
LAN Ports
Voice
Connectors
Ingress
