A C C E S S 2 4 1 - F X O / 2 4 1 / 2 1 1 / 2 1 1 N V O I P G A T E W A Y U S E R G U I D E
MN100129 Rev E
15
9.
Connect the power adapter to the Gateway’s power connector on the rear of the unit.
Connect the power adapter to a wall socket.
10.
Check that the
Power
LED on the Gateway’s front panel glows steadily.
12.
T urn on the PCs. For each PC perform the following:
12a. If you are using a DSL modem, you will need to enable PPPoE on the Gateway and disable
PPPoE on the PC. To enable PPPoE on the Gateway:
9)
Open the web browser and put the IP of the Gateway in the address field (the
factory default IP address of the LAN interface is 192.168.100.1).
10)
In the vertical menu bar on the left of the Gateway Web page, select
W AN
.
The
W AN Status
page appears.
11)
In the horizontal menu bar of the
W AN
page, select
PPPoE
.
T he
W AN PPPoE
Configuration
page appears.
12)
Select
Ye s
in the
Enable PPPoE
drop-down list box.
13)
Fill in the username and password in the
Authentication
fields as supplied by your
DSL provider. Optionally you can enter the service name for the requested service.
To select a specific provider, enter his access name in the AC name field.
14)
Click
Save PPPoE Se ttings
.
15)
After entering and saving all configurations, you must reset the Gateway. In the
vertical menu bar of the current page, select
Reset
.
The
Reset
page appears.
16)
Select
Powe r on rese t
and click the Reset button. T he Gateway power cycles and
the application’s home page opens with the new configuration settings.
For more information see section “
Enabling Point-to-Point Protocol over Ethernet
)”.
12b. If you are using a cable modem, note that some cable modems need to be powered off and
then on after being connected to the Gateway. For such modems you can also power off the
Gateway and then power on for faster connection.
13.
Wait for the
Voice
LED on the Gateway front panel to glow, indicating connection to your
Internet and VoIP providers. It may take a minute or two for these connections to be
established.
14.
Verify that your broadband Internet service functions properly.
15.
Pick up the phone on each line to verify that you can hear the dial tone.
Once the installation is complete, you can use your Gateway for telephone calls and for the Internet,
assuming that you have a connection supplied by your VoIP provider.
If any problems are experienced during the installation of the unit, please contact your local vendor.
