www.tekvox.com
4K PTZ Camera
79068-4K-12 User Manual
3. Application Instruction
3.1 Video Output
3.1.1 Power-On Initial Configuration
The remote control receiving indicator flashes after powering on, the pan-tilt turns left to the lowest
left to the lowest, and then turns to the HOME position (both the horizontal and vertical positions are
in the middle), while the movement first shrinks and then stretches. When the remote control
receiving indicator stops flashing, the self-checking is completed. After powering on and self-
checking, the camera will automatically return to the preset 0 position if it’s pre-set.
3.1.2 Video Output
Connect to the video output cable: the user can refer to §1.4 Product Interfaces.
1.
Network output: Connect this product and your computer through a network cable, then open
the browser, enter the camera IP address (factory default 192.168.5.163) in the address bar,
then go to the login page and input a username and password (factory defaults are “admin”).
Finally, enter the preview page, and the image will appear.
Note: If you forget your username, password, or IP address, you can manually restore the default
with the RESET key at the bottom of the machine.
2.
HDMI output: Connect the monitor with the corresponding video output interface, and then the
monitor outputs image.
3.
USB 3.0 output: Connect the camera with the computer USB 3.0 interface (blue), open the
Device Manager to see whether there is an imaging device, and whether the Universal Serial
Bus controllers recognize the USB 3.0 device. After properly identification, open the software,
choose the imaging device, and it will then display the image.
4.
USB 3.0 (compatible with USB 2.0) output: Connect the camera with a USB 2.0 interface
(black), and then open the Device Manager to see whether there is an imaging device and
whether the Universal Serial Bus controllers recognize USB 3.0/USB 2.0 device. After proper
identification, open the software, choose the imaging device, and then it will display the image.
